veneer repair

  • Thread starter Thread starter Striker
  • Start date Start date

You are reading the forum of the Society of American Period Furniture Makers — people who build and study American period furniture.

Membership brings the whole forum, the annual journal and quarterly magazine, the members’ gallery and workbench, and chapters across the country. About membership

S

Striker

Guest
I know we have a number of accomplished restorers in the ranks.  I was hoping to call upon some of that talent base for guidance today.  A coworker of mine tinkers with old tube radios.  He recently asked for a little help with a veneer problem on a small 1930s radio case.  The veneer on top has become loose in areas which lead to several chips being lifted and broken off.  The veneer edge may have caught on something and pealed back until it chipped off.  The largest chip is roughly ½ wide and maybe 5/8 long. 

I have some generalized thoughts  about how to go about the repair but I'm told it's a very rare radio. Hence, I'm a little apprehensive about going about it in the wrong fashion.  Some questions in my mind are what glue would be appropriate? Would hide glue still been used1930s?  Finish?


Thanks, Stephen
 
yes the glue is most likely hide, but even if it is not you can do the repair with hide glue without doing any damage it is reversible and probably preferred. If the radio was made in a factory in the 30's it is probably lacquer, most factories had switched to lacquer from shellac by then, but to be sure do an alcohol test on the edge of the repair where you will need to repair the finish any way.
 
Thanks guys - excellent points.  I was hoping hide glue was used so I can re-constitute the glue and get the veneer back down.  He has a donor radio case as well to steal some veneer.

Stephen
 

If this discussion was useful, there are twenty years of them here. Join SAPFM to take part — the forum, the journal, the magazine and the members’ gallery come with membership.

Back
Top