I am making a Philadelphia chair with through tenons. Did the original chairs have wedges in the tenon in the back or were these repairs add later? I saw a close-up picture of a reproduction from Kittinger and it had no wedges in the back. Also what is the best way to do the through tenon so that there are no gaps in the back?
Through tenons
- Thread starter daveknuth
- Start date
You are reading the forum of the Society of American Period Furniture Makers — people who build and study American period furniture.
Membership brings the whole forum, the annual journal and quarterly magazine, the members’ gallery and workbench, and chapters across the country. About membership
Everything I have seen and read showed the wedges on the originals, which of course make sense. I have done these once, and I was able to get a decent fit by marking and mortising from the back of the leg as well as the front, so the opening that shows is clean. I think this is discussed in the Clarkson chair book but it's been a while since I opened it.
Once the tenon is wedged, you can plane/scrape everything flush and that action helps to close gaps, similar to final planing dovetails.
I'm sure there are more experienced hands than me, but it wasn't a difficult process. Good luck on yours! Cal
Once the tenon is wedged, you can plane/scrape everything flush and that action helps to close gaps, similar to final planing dovetails.
I'm sure there are more experienced hands than me, but it wasn't a difficult process. Good luck on yours! Cal
Attachments
In 1986 Gene Landon wrote an article on constructing a chippendale ladderback chair for FWW. Every thing you need to know about the joinery,especially the rear post tenons is in this article. The FWW mag has the chair on the cover and is available on Ebay(I just looked). Good Luck
If this discussion was useful, there are twenty years of them here. Join SAPFM to take part — the forum, the journal, the magazine and the members’ gallery come with membership.