slotted screw holes to allow wood movement

You are reading the forum of the Society of American Period Furniture Makers — people who build and study American period furniture.

Membership brings the whole forum, the annual journal and quarterly magazine, the members’ gallery and workbench, and chapters across the country. About membership

S

sliv33

Member
Can someone tell me if the slot to allow wood movement should be equal to, or larger than the diameter of the screw, for example when attaching a top to an underlying moulded frame?  Thanks.
Arnold
 
I can only tell you what I do...and that is make it one size (1/64") larger than then the screw.  You want the top to move freely. 

I saw a neat trick (mind not very period trick), but if you have a Festool Domino, you go all the way through with the smallest size and then plunge in just a tad with a larger size make resessed spot for a flat head screw to sit.

martin
 
Martin,

Again, not terribly period, but most major router brands now sell bits that cut both the through slot and a counterbore or countersink in one tool.

Ralph
 
Thanks for your input.  Sorry for the delay in getting back to you , but have been out of commission for the past three months.  Arnold
 
You must log in or register to reply here.

If this discussion was useful, there are twenty years of them here. Join SAPFM to take part — the forum, the journal, the magazine and the members’ gallery come with membership.

Back
Top