Roxbury Cornice

You are reading the forum of the Society of American Period Furniture Makers — people who build and study American period furniture.

Membership brings the whole forum, the annual journal and quarterly magazine, the members’ gallery and workbench, and chapters across the country. About membership

P

psanow

Member
Apparently I'm following the crowd and also building a Roxbury-inspired clock.  While communicating with another member I was told that the grain should run vertically in the arched cornice moulding.  I don't have a period example handy to examine but the photos I've looked at seem to show maybe a few running vertically and a some horizontal (and many others I can't determine).  I was a bit surprised by that as it would likely be cross grain with the arch framing behind.  Can anyone shed light on this?

I think of greater note is that the entire front elevation of the cornice appears in many examples to be one piece- arch and flats as one piece before returning around the sides.  Am I misreading a very tight and well blended joint?  See photo from Simon Willard piece at NYC Met Museum.  Similar from my photos of the Doull/Seymour clock.

I expect I'm using gouges and scrapers to make this.

Thanks
Paul Sanow
 
I just finished making five 1799 Aaron Willard Roxbury style cases. I had full access to the original which is in the city hall of Huntersville, NC. Four of the reproductions are in nearby Davidson, NC. I asked a similar question on the post prior to this one. The grain on this clock ran horizontally, I turned the cornice two at a time on the lathe, I then cut the miter on the turned cornice and on the straight blank, I traced the profile on to mitered end of the straight section and planed the straight section with hollows and rounds.
 
You must log in or register to reply here.

If this discussion was useful, there are twenty years of them here. Join SAPFM to take part — the forum, the journal, the magazine and the members’ gallery come with membership.

Back
Top